pinning up the MMM on my Kubota B2650

[Storian]

I tried the pin-up procedure on my Kubota B2650's MMM so I could use the 3-point. After an hour of twisting, reading, and cussing, I quit, has anyone actually done this successfully?

 

[zetian.zaijian]

I tried the pin-up procedure on my Kubota B2650's MMM so I could use the 3-point. After an hour of twisting, reading, and cussing, I quit, has anyone actually done this successfully?

Honestly? I've done it on my B2650 and it's a pain, but patience pays off. Make sure the lift arms are perfectly aligned before trying to pin, it makes a huge difference.

 

[Storian]

Good to know it's possible, did you find there's a trick to lining up the arms faster, or is it really just trial and error every time?